Denon AVC-A1HD Owner's Manual page 38

e U se ui p to input the address and press
IP Address :
Set the IP address within the ranges shown below. The Network
Audio function cannot be used if other IP addresses are set.
CLASS A: 10.0.0.0 ~ 10.255.255.255
CLASS B: 172.16.0.0 ~ 172.31.255.255
CLASS C: 192.168.0.0 ~ 192.168.255.255
Subnet Mask :
When connecting an xDSL modem or terminal adapter directly
to the AVC-A1HD, input the subnet mask indicated in the
documentation supplied by your provider. Normally input
255.255.255.0.
Default Gateway :
When connected to a gateway (router), input its IP address.
Primary DNS Secondary DNS :
If there is only one DNS address indicated in the documentation
supplied by your provider, input it at "Primary DNS". If there are
two or more DNS addresses, input the first one at "Secondary
DNS".
ENTER
r U se i to select "Exit" and press
Setup is complete.
b When connecting to the network via a Proxy server, select "Proxy"
ENTER
and press (vpage 36 "Proxy settings").

Wireless LAN settings
ENTER
.
Use this procedure to configure the Wireless LAN settings.
1
Fitting a rod antenna (vpage 20).
b If a LAN cable is connected, remove it.
2
Turn on the AVC-A1HD (vpage 54).
3
Set the access point at the GUI menu "Manual Setup"
– "Network Setup" – "Network Setup".
When searching access points to connect automatically, refer to
"Automatic settings".
When searching access points to connect manually, refer to
"Manual settings".
n Automatic settings
.
q S elect "Search" and press
The access point you have set is displayed.
w U se ui to select the access point, and then press
q Select "Search".
w S elect the access point.
Example) DENON
ENTER
.
ENTER
.
b If the access points are not detected automatically, use i to
ENTER
select the "Manual" and press .
Setting becomes manual. For details, see "Manual settings"
(vpage 35, 36).
Select when access
points cannot be searched
automatically.
b If the access points are repeat search, use i to select the
ENTER
"Search" and press .
Select when searching
access points again.
e I f there is an encryption setting for the access point you selected
in step w, enter same encryption key as used for the access
point. (If there is no encryption setting, proceed to step t.
r S et only during
"WEP" in step w.
t Select "Connection".
e Enter
encryption key.