Location - Electrolux EKM6700X Instruction Booklet

Location

Carry out installation as described in the
Installation Requirement chapter-paragraph 2.4 of
AG 101-2000.
Choose a location free of draughts and open doors and
clear of combustible materials or other fire hazards such
as curtains, etc.
The location should ensure convenience of operation and
service. Any adjacent wall surface situated within 200
mm from the edge of any hob burner and above the height
of the hob must be a suitable non-combustible material
for a height of 150 mm for the entire depth and width of
the cooker. If the hob is below the bench top, a clearance
of 100 mm must be provided.
Any combustible material above the hotplate must be at
least 650 mm above the top of the hob and no
construction shall be within 450 mm above the top of the
burner.
Fitting the Stability Bracket
The stability bracket supplied with the cooker must be
fitted by the installer (see picture).
1. Place the cooker in its intended position and mark
the cooker height, taken from the top of the trivets
(splashback removed).
2. Mark 720mm below the cooker height. This is the
position of the stability bracket (position of the stability
bracket can be either side of the counterweight, i.e.
not centrally located).
3. Fix the stability bracket (using two of the provided
five fixing holes) to the rear wall (see diagram).
4. Pull the cooker towards the rear wall as shown in the
diagram. The stability bracket should then come into
contact with the bottom panel of the cooker.
Check that the stability bracket securely prevents the
cooker from accidently tipping forward when a downward
force is applied to the open oven door.
100
100
FO 0181
100
27