Program Values - Bosch GWH C 800 ES Installation Instructions Manual

Fig. 64 Adjusting P2 CO
Program Description
P1 Maximum Power
P2 Minimum Power
P3 Remote
Controls installed
P4 Access to
Diagnostic Mode
P5 Cascade Mode
P6 Temperature Unit
P7 Appliance Type
P8 Back light
P9 Fan Purge
Table 16 Program values, factory default settings and ranges.
6 720 608 643
level
2
Factory Default
NG:51, LP:50
12
_0
E
NO
°F
Cd
dE
6.6

Program values

This section describes details on programming the
appliance. For most applications the factory default
values will provide robust and stable operation. Only
adjust the factory settings if the installation requires
changes as indicated in the appropriate section of this
manual.
Refer to 6.7 Control board diagnostics (page 35)
regarding how to access these P-modes.
Caution:
values can
malfunction, errors, and service
calls.
MIN MAX
21 NG:51, LP:50
12 20
_0 6
0d 10f
NO CC
°F °C
Cd NO
dE ON
Maintenance and service
Misadjusted program
lead to appliance
Comment
see chapter 3.13, page 26
note: reducing P1 values below
maximum will reduce maximum
power of the appliance.
see chapter 3.12.2, page 18
see chapter 5.5, page 30
see chapter 6.7, page 36
contact Bosch for details
Condensing / Non-condensing
note: incorrect setting will cause
errors.
dE turns back light off after 60
seconds from last button pushed,
ON turns backlight
permanently
runs secondary fan when P9 is
selected by depressing the "P" -
button
on
35