D-Link DI-524 Manual page 30

Hide thumbs Also See for DI-524:

Table of Contents

Using the Configuration Menu (continued)

Advanced > Performance

Beacon Interval-

RTS Threshold-

Fragmentation-

DTIM Interval-

Wireless Mode-

TX Rates-

SSID Broadcast-

Beacons are packets sent by an Access Point to synchronize

a wireless network. Specify a value. 100 is the default setting

and is recommended.

This value should remain at its default setting of 2432. If incon-

sistent data flow is a problem, only a minor modification should

be made.

The fragmentation threshold, which is specified in bytes, deter-

mines whether packets will be fragmented. Packets exceeding

the 2346 byte setting will be fragmented before transmis-

sion.2346 is the default setting

(Delivery Traffic Indication Message) 3 is the default setting. A

DTIM is a countdown informing clients of the next window for

listening to broadcast and multicast messages.

Select Short or Long Preamble. The Preamble defines the

length of the CRC block (Cyclic Redundancy Check is a com-

mon technique for detecting data transmission errors) for

communication between the wireless router and the roaming

wireless network adapters. Note: High network traffic areas

should use the shorter preamble type.

Auto is the default selection. Selct from the drop down menu.

Choose Enabled to broadcast the SSID across the network.

All devices on a network must share the same SSID (Service

Set Identifier) to establish communication. Choose Disabled

if you do not wish to broadcast the SSID over the network.

Table of Contents

Show Quick Links

Table of Contents