DORO CARE LOCATION OF CONTROLS Telephone hook switch Direct memories Socket for external alarm button Handset earpiece volume Last number redial Ringer Off/Low/High Telephone line cord socket Speaker phone button Recall button Ring signal indicator Power supply (PSU) socket Power indicator (Green light)
Please contact your retailer, if an item is missing or damaged. IMPORTANT INFORMATION The DORO CARE has been designed and manufactured to give safe operation, and ease of installation and use. WARNING: Emergency service numbers 999/112 etc, must not be programmed into memory.
# Ensure Earpiece volume is set to minimum. Lift the handset and check if there is dial tone, adjust the earpiece volume as required. HEARING AID COMPATIBLE The DORO CARE is hearing aid compatible. Switch your hearing aid to the T position. LOCATING THE TELEPHONE # The DORO CARE should if possible be connected to your network master socket.
DORO CARE FOR TECHNICAL HELP SEE PAGE 10 SPEAKERPHONE FUNCTION You may upon connection of the telephone, or, upon moving it to another network telephone socket, find the speakerphone function initially will not operate. This can be overcome by lifting the handset for 2-3 seconds. The speakerphone will not operate if the backup batteries and mains power adaptor (PSU) are not installed.
DORO CARE FOR TECHNICAL HELP SEE PAGE 10 VOLUME CONTROL The level in the handset and the speakerphone can be adjusted using the switches located on the right hand side of the telephone. Volume control for the handset (5 steps).
If the person called then presses the # button, this will activate the DORO CARE hands free function. (REFER TO ‘ WARNING’ ON PAGE 4). If there is no response the DORO CARE will wait for 60 seconds before dialing the next memory number.
# For reference a picture or symbol can be placed under the sliding cover. # The people whose numbers are programmed into memory should be advised on the Alarm Response Options available when they receive a call from the DORO CARE.
DORO CARE FOR TECHNICAL HELP SEE PAGE 10 ADVANCED ALARM SETTINGS From new the telephones alarm settings are preprogrammed. These can be altered by using the four, two position switches on the underside of the telephone. # Carefully remove the retaining screw and slide the cover out.
DORO CARE FOR TECHNICAL HELP SEE PAGE 10 HOW THE ALARM WORKS No Mode Explanation Setting STANDBY Alarm not activated ALARM Pressed. The unit will wait the 0 or 10 seconds can selected time before the alarm will be be selected activated.
THE PHONE DOES NOT RING # Check the total REN on the line does not exceed 4. The DORO CARE is REN 1. # Check the ringer switch on the right hand side of the telephone is not set to Off.
Date of issue:2000-08-17 Copies of this document will be held on file for a period of 10 years after the last production. Supplier: DORO AB, Skiffervägen 80, SE-224 78 LUND, SWEDEN Product: DORO CARE This product is intended for connection to analogue PSTN lines within the following countries: Sweden, Norway, Denmark, Finland, United Kingdom, Switzerland, France and Iceland.
Need help?
Do you have a question about the CARE and is the answer not in the manual?
Questions and answers