Table of Contents
Advertisement
Safety system
When the food is cooked
Changing the settings
The oven grill is
adjusted as follows
If the gas coming out of the oven burner is turned off
for some reason, the safety system will be activated
and the gas flow cut.
d
Do not use the ignition system for more than 15
seconds. If the burner does not ignite within 15
seconds, stop using the mechanism and wait for at
least 1 minute before you attempt to ignite the burner
once again.
6. Check the burning of the gas by looking through
the inspection hole in the bottom iron panel in the
oven. If there are no flames, repeat the above
steps starting with step 3.
7. Close the oven lid slowly.
8. Preheat the empty oven for 15 minutes, then start
baking.
Turn off the function selector switch.
You can change the heat settings anytime you like.
1. Open the upper lid. The upper lid must be kept
open as you bake.
2. Turn on the main gas switch of the appliance.
Connect the appliance to the mains. Open the
oven lid.
3. Attach the protective sheet to the channel that is
under the control panel. Place the sheet iron with
its longest end facing the front and the curve in the
tip looking down. The protecting plate is secured
using the clips in the recess below the control
panel. Ensure that the protecting plate is properly
engaged in the clips. If the protecting plate is
properly engaged, you will not be able to pull it any
further towards you. You can now use it safely. If
the protecting plate is not properly engaged, try to
insert it into the recess at a slightly sharper angle
and engage it in the clips.
4. Close the oven lid until it is as close as possible to
the protective sheet.
29
Advertisement
Table of Contents
