Table of Contents
Advertisement
Electrical
connection
For the authorised
service employee
12
Installation must be carried out by an authorised service
employee. A 16A circuit breaker is required for the
connection. The appliance has been designed to be used
with 220 240V mains current.
If the voltage drops below 180 V, then the electrical igniter
system will not function.
All warranty rights will be invalidated if damage occurs due to
incorrect connection and installation.
The device must be connected according to the information
on the identification plate.
Connect the appliance only to an electrical connection that is
in compliance with the regulations. Once the appliance has
been connected, it must be possible to reach the connection
point easily so that it can be disconnected.
A multi pole separator system must be provided.
The use of extension cables and multi socket adapters is
forbidden.
This appliance must be operated with an earthed connection
to provide adequate electrical safety. If the appliance is not
earthed in accordance with regulations, then protection
against hazards in the electrical system cannot be guaran
teed.
H 05 W F or an equivalent type of cable should be used to
connect the appliance.
Advertisement
Table of Contents
