Electrical Connection - Bosch HSG223055Z Instruction Manual

Problems with the
gas installation /
smell of gas
Electrical
connection
For the authorised
service employee
If an approved safety hose is used then care must be
taken to ensure that it is not squashed or crushed in
any way. The hose must not come into contact with
hot surfaces.
The gas may be connected (gas pipe or safety gas
hose) to the left or the right side of the appliance. The
connection must have an easily accessible shut off
device.
If you smell gas or notice defects in the gas
installation, you must:
- immediately close the gas supply or the gas bottle
valve
- immediately put out any naked flames and
cigarettes
- switch off electrical devices, including lights
- open the window and ventilate the room well
- call the after sales service or your gas supplier.
Installation must be carried out by an authorised
service employee. A 16A circuit breaker is required for
the connection. The appliance has been designed to
be used with 220 240V mains current.
If the voltage drops below 180 V, then the electrical
igniter system will not function.
All warranty rights will be invalidated if damage occurs
due to incorrect connection and installation.
The device must be connected according to the
information on the identification plate.
Connect the appliance only to an electrical
connection that is in compliance with the regulations.
Once the appliance has been connected, it must be
possible to reach the connection point easily so that it
can be disconnected.
A multi pole separator system must be provided.
11