Clearances To Combustibles; Insert Leveling - Lennox Hearth Products Elite Series Installation And Operation Manual

Elite series b-vent gas fireplace inserts
Table of Contents

Advertisement

Minimum Clearances to Combustibles
Minimum clearances include any projections such as shelves, window
sills, mantels, spacers/standoffs or surfaces to combustible construction
etc. above the appliance. Paint or lacquer used to finish the mantel
must be heat resistant in order to avoid discoloration.
The letters below, E through J, correspond to Figure 4 showing minimum
clearances required from the appliance to combustibles and the minimum
projection of the hearth extension.
E & J = 32.0" (813mm) from Top Facing or Mantel to Bottom of In-
sert
F 52.2
= 10.5" (267mm) from Edge of Glass to Side Facing or Side
Wall
Hearth Protection
G = Minimum Hearth Protection from Front of Insert*
H = Vertical Distance from Insert Bottom to Combustible Material.
13"
G
(330mm)
0"
H
(0mm)
10"
0"
(54mm)
(0mm)
"
4"
(1mm)
(10mm)
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Clearances
MANTEL
Mantel
TRIM
Trim
E
G
Figure 4
Note: Hearth protection to be min. 3/8" (10mm) thick non-combustible
or equivalent, with a k factor of .84.
Insert Leveling
At each front and rear corner of the insert is an adjustable leg provided
to level the insert should the hearth of the fireplace be uneven. To adjust
the legs, loosen the two 5/32" allen head screws, move the leg to the
desired height and then tighten the screws. Repeat these steps for each
adjusting leg.
WARNING
B-Vent appliances are not designed to operate
in negatively pressured environments (pressure
within the home is less than pressures outside).
Significant negatively pressured environments
caused by weather, home design, or other devices
may impact the operation of these appliances.
Negative pressures may result in poor flame
appearance, sooting, damage to property and/or
severe personal injury. Do not operate these
appliances in negatively pressured environments.
Providing adequate ventilation to the appliance for
combustion air will eliminate a negative pressure
environment.
F
C L
H
Hearth / Floor Protection
J
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elite designerElite dbv

Table of Contents