Electrical Connection - AEG ARCTIS Operating Instructions Manual

Installation

Electrical Connection

The plug socket necessary for connection of your appliance to the
electricity supply should be positioned so that it is possible to pull out
the appliance plug.
If your appliance is installed under a
continuous worktop, the plug socket
should be provided as shown.
Alternatively a concealed spur socket
fitted with a 13 A fuse may be fitted.
If the socket is not accessible once
the appliance is built in, the electrical
installation must include suitable
means of isolating the appliance from
the mains (e.g. fuse, cut-out, current
trip or similar with a minimum con-
tact separation of 3 mm).
Before initial start-up, refer to the appliance serial plate to ascertain if
supply voltage and current values correspond with those of the mains
at the installation location.
e.g.: AC 220 ... 240 V
(i.e. 220 to 240 volts alternating current, 50 Hertz).
The rating plate is inside the appliance on the left.
34
220 ... 240 V
AEG44
50 Hz or
~50 Hz
130
300