Honda 2003 ST1300lA Owner's Manual page 165

If Fuse Blows
a
4. To check or replace a circuit fuse, pull the old fuse out of its retaining clips
with the fuse remover. Look for a burned wire inside the fuse. If the fuse is
blown, replace it with a spare fuse of the same rating or lower.
5. Close the fuse box cover and install the left side cover (page 88).
Main Fuse A
1. Remove the right side cover (page 88
2.
Disconnect the wire connector of the starter magnetic switch.
Pull out the old fuse and install a new fuse.
3. The spare fuse is located behind the starter magnetic switch.
4. Reconnect the connector and install the right side cover (page 88).
RIGHT SlDE
wire connector
spare main fuse
Main Fuse B
1. Remove the right side cover (page 88
2.
Remove the fuse cover.
3. Loosen the screws then replace the fuse.
After replacing the fuse, tighten the screws.
Install the fuse cover and right side cover (page 88).
RIGHT SlDE
164
of
Taking Care the Unexpected
).
).
fuse cover
main fuse A
main fuse B