GoVideo R6750 User Manual page 40

Troubleshooting
SYMPTOM
Picture or sound of broadcasting
channel is weak or missing.
Camcorder image via A/V input
or DV IN to DVD Recorder is not
shown on TV screen.
Can't play disc recorded on this
DVD Recorder on another DVD
player.
Cannot record or did not record
successfully.
Timer Recording does not work.
Stereo Audio Recording and/or
Playback not present.
Remote control does not work
properly.
40
DVD Recorder User's Guide
CAUSE
Antenna or cables are loose.
Wrong TV Signal is selected in the
DVD Recorder Setup menu.
Camcorder is off.
DVD Recorder's input is not set to
AV1-Front, AV2-Rear, S-Video, or DV.
The DVD+R disc was not finalized.
Some players will not play even a
finalized disc.
The remaining blank space on the
disc is insufficient.
The source you are trying to record is
copy- protected.
When setting the recording channel,
the channel is tuned to the TV's own
tuner.
DVD Recorder is not set to the
correct time.
Timer has been programmed
incorrectly.TIMER indicator light does
not appear after programming timer.
DVD Recorder is on.
TV is not Stereo-compatible.
Broadcast program is not in stereo
format.
DVD Recorder A/V Out jacks are not
connected to TV A/V In jacks.
DVD Recorder Audio/Video Out is not
selected for viewing at the TV.
The remote control is not pointed
at the remote sensor of the DVD
Recorder.
The remote control is too far from the
DVD Recorder.
There is an obstacle in the path of
the remote control and the DVD
Recorder.
The batteries in the remote control
are exhausted.
SOLUTION
Tighten connections or replace cable.
See "TV Signal" on page 27.
Turn camcorder on and operate
properly.
Press INPUT to select the correct
input.
Finalize the disc; see page 37.
No solution.
Use another disc.
You cannot record the source.
Select the channel on the DVD
Recorder's built-in TV tuner.
Set date and time; see page 22.
Reprogram Timer; see page 31.
Turn off the DVD Recorder.
No solution.
No solution.
Make A/V connections. Stereo is
available only via A/V output from
DVD Recorder.
Select AUX or A/V source as TV input.
Point the remote control at the
remote sensor of the DVD Recorder.
Operate the remote control within
10 ft (3 m).
Remove the obstacle.
Replace the batteries with new ones.