Automatic Device Calibration - Blaupunkt TravelPilot Amsterdam NAV 35E Operating And Installation Manual

INTRODUCTION NAVIGATION

Automatic device calibration

(only TravelPilot and speed signal "ON")
The TravelPilot must be calibrated after it is installed.
Note: The navigation CD-ROM must already be inserted in the drive
before you can do this.
1 Mark and confirm the AUTOmatic CALIBration menu item.
The system displays a message asking you to drive 3 to 10 miles (5 to 15 km)
with GPS reception. Wait approx. 15 seconds or press the OK button ;. An
indicator bar will appear together with a figure in percent informing you of the
progress of the calibration process.
2 Now start driving.
The menu closes automatically when the calibration process has completed
(the indicator bar fills completely and the system displays 100%).
Note: You must drive along major national roads (A-roads) or main
secondary roads (country roads) during calibration. The length of the
route that is specified by the system is only an average value. It can also
be shorter or considerably longer if conditions are poor. The final fine
calibration is completed after approximately 31 miles (50 km).
RADIO CD / MP3 CD CHANGER SETUP
ins=all
INST. TEST
AUTO CALIB
TMC
MAN. CALIB
SPEED
au=o Calib
TMC
RESTART?
APPENDIX
92
NAV
O%
NAV