Turn off power to eliminate risk of shock during installation
Watch the installation video at LaunchPort.com/support
1
Locate desired area for WallStation and
Locate desired area for wall plate and
trace cutout and screw locations. Use a
trace cutout and screw locations.
stud finder to locate studs. Use a level to
*NOTE: wall plate must be within 2 feet of
ensure a level trace.
a power outlet.
7
Attach connectors to both ends of the
Plug connector into wall plate.
wire. Wires must be installed in exactly
the same orientation on both connectors.
12
Attach fascia to WallStation.
Plug power adapter into electrical recepti-
cal and plug power adapter DC plug into
wall plate.
2
3
Cut opening for WallStation and wall plate
using a drywall saw.
8
9
Plug connector into WallStation.
13
14
The WallStation is ready to use. Enjoy!
4
Run supplied wire from WallStation cutout
Receive wire through wall plate cutout.
to wall plate cutout.
*NOTE: For help going through a fire-
*NOTE: if wiring over 6 feet of distance
block refer to: LaunchPort.com/support
refer to Wire Sizing Chart below.
10
Attach WallStation to the wall using
Mount wall plate on wall using supplied
supplied screws.
screws.
TOOLS REQUIRED
Drywall Saw
#2 Phillips Screwdriver
Level
Measuring Tape
5
Using a screwdriver, install the anchors
for the WallStation and wall plate.
*NOTE: For best results pre-drill holes.
11
BOX CONTENTS
WIRE SIZING CHART
WallStation Assembly
MAX LENGTH
GAUGE
WallStation Fascia
25'
24 AWG
wall plate
40'
22 AWG
Power Supply
Cut-out Template
60'
20 AWG
6ft. 18 AWG Electrical Wire
100'
18 AWG
6 Drywall Anchors
150'
16 AWG
Mounting Screws for WallStation
Mounting Screws for wall plate
*Additional wire not included
6
Need help?
Do you have a question about the LaunchPort and is the answer not in the manual?
Questions and answers