Replacing The Charcoal Filter - Electrolux EFC9062 User Manual

Before carrying out any maintenance
or cleaning isolate the cooker hood
from the mains supply.

Replacing the Charcoal Filter

This fi lter cannot be washed or
regenerated, and must be replaced
when the F touch control starts to fl ash,
or at least once every 4 months. The
alarm is only triggered when the motor
is on.
Enabling/Disabling the alarm signal
• In Recirculation
the Filter saturation Alarm must be
enabled at the time of installation or
later.
• Switch off the lights and the motor.
• Disconnect the mains power supply
to the hood by removing the motor
unit power supply cable connector,
switching off the power supply at the
Mains or turning the Main switch off.
• Restore the connection, pressing and
holding T2.
• Release the touch control, touch
controls L, T2 and F will light up
normally.
• Within 3 seconds press the touch
control F until the key itself fl ashes to
confi rm as follows:
• 2 fl ashes – Charcoal Filter saturation
Alarm ENABLED
• 1 fl ash - Charcoal Filter saturation
Alarm DISABLED
MAINTENANCE AND CLEANING
Version Hoods,
Reset the alarm signal
• Stop the motor.
• Press the touch control F for at least
4 seconds, until the touch control T1
fl ashes.
Replace the Filter
• Pull the suction panel to open it..
• Remove the metal grease fi lters.
• Remove the saturated charcoal fi lter,
turning the fasteners provided.
• Fit the new fi lter and fasten it its
correct position.
• Put the metal grease fi lters in their
seats.
• Close the suction panel.
This appliance can be a possible fi re
hazard if the grease and charcoal fi l-
ters are not cleaned and replaced as
recommended.
electrolux 11
EN