Advertisement
Quick Links
MA1306-EA
Your watch may differ somewhat from the one shown in the illustration.
Some models may use a combination of hands and rotating disks to indicate
information. The word "hand" in this section is used to mean both analog hands
and rotating disks.
Stopwatch Minute Hand
Second Hand
Stopwatch Second Hand
Stopwatch functions
When the second hand is at
12 o'clock, pull the
Click 2.
Rotate the
Crown
to change the
time setting.
Push the
back in.
Crown
Note
Take care that you set the correct AM
or PM time.
When changing the time, move the
minute hand four or fi ve minutes past
your fi nal setting, and then back it up
to the setting you want.
Some water-resistant models (100 meters, 200 meters)
have a screw-in crown. When you need to perform a crown
operation, rotate it towards you to unscrew it. Then pull
the crown out. Avoid applying undue force when pulling.
The watch loses its water resistance while the crown is
unscrewed. After performing a crown operation, fully screw
the crown back in.
You can rotate the bezel to align its ▼ mark with the
minute hand. Then you will be able to tell how much
time has elapsed since aligning the ▼ mark.
Operation Guide 5372
Stopwatch 1/10-Second Hand
Hour Hand
Minute Hand
A
Click 1
L
B
Crown
Day Indicator
Pull the
out to Click 1.
Crown
out to
Crown
Rotate the
Crown
to set the day.
Push the
back in.
Crown
Note
The day indicator setting uses a 31-
day month. Make adjustments for
months of shorter lengths.
Avoid changing the day indicator
setting between the hours of 9
p.m. and 1 a.m. Otherwise, the day
indicator may not change correctly at
midnight.
Current
The stopwatch measures elapsed time in 1/10-second increments up to 59 minutes,
59.9 seconds.
Elapsed time
A
Start
Split time
A
Click 2
Start
Two fi nishes
A
Start
Important!
Do not operate the stopwatch with the crown pulled out.
Note
An elapsed time operation will stop automatically at the end of 60 minutes.
Perform the following procedure if the stopwatch hands do not return to their 0 (zero)
positions when you reset the stopwatch.
Pull the
Crown
Press A to move the
Holding down A will move the hand at high speed.
Press B to move the
Holding down B will move the hand at high speed.
The
Stopwatch Minute Hand
After all of the hands are the way you want, push the
Important!
Timekeeping stops while the crown is pulled out. Correct the current time setting
after performing the above operation.
Crown
Hold down L.
Note
Illumination remains turned on as long as L is depressed.
Illumination will turn off about four seconds after L is released.
Loosen
Start
Illumination may be hard to see when viewed under direct sunlight.
Frequent use of illumination runs down the battery.
Elapsed time
Accuracy: ±20 seconds average per month
Stopwatch: Measuring Capacity: 59'59.9" (60 minutes)
Measuring Unit: 1/10 second
Measurements: Elapsed time; split time; two fi nishes
Illumination: LED (light-emitting diode)
Battery: One silver oxide battery (Type: SR920SW) and one lithium battery
(Type: CR1616)
Battery Life: Approximately 2 years (60 minutes stopwatch operation and 16 seconds
illumination per day)
Always have both batteries replaced at the same time.
A
A
A
Stop
Re-start
Stop
B
A
B
Split
Split release
Stop
A
B
B
Split
Stop
Split release
Display time of
First runner
Second runner
second runner.
fi nishes.
fi nishes.
Display time of fi rst
runner.
out to Click 2.
clockwise.
Stopwatch 1/10-Second Hand
clockwise.
Stopwatch Second Hand
is synchronized with the
Stopwatch Second Hand
Crown
B
Reset
B
Reset
B
Reset
.
back in.
1
Advertisement
