Advertisement
Quick Links
Operation Guide 5373
Your watch may differ somewhat from the one shown in the illustration.
Crown Operations
Some water-resistant models (100 meters, 200 meters)
have a screw-in crown. When you need to perform a crown
operation, rotate it towards you to unscrew it. Then pull the
crown out. Avoid applying undue force when pulling. The watch
loses its water resistance while the crown is unscrewed. After
performing a crown operation, fully screw the crown back in.
If your watch has a rotary bezel...
You can rotate the bezel to align its ▼ mark with the
minute hand. Then you will be able to tell how much
time has elapsed since aligning the ▼ mark.
Specifi cations
Accuracy: ±20 seconds average per month
Illumination: LED (light-emitting diode)
Battery: One silver oxide battery (Type: SR920SW) and one lithium battery (Type:
CR1616)
Battery Life: Approximately 3 years on type SR920SW and type CR1616 (assuming one
9-second illumination operation per day)
Always have both batteries replaced at the same time.
Click 2
Click 1
Crown
Crown
Loosen
Start
Elapsed time
Current
Illumination Precautions
To adjust the time setting
When the second hand is at 12 o'clock, pull
the
out to Click 2.
Crown
Rotate the
to change the time setting.
Crown
Push the
Crown
back in.
To change the day and day of the week settings
Pull the
Crown
out to Click 1.
Rotate the
Crown
towards you to set the day.
Rotate the
away from you to set the
Crown
day of the week.
Push the
Crown
back in.
To turn on illumination
Hold down L.
Note
Illumination remains turned on as long as L is depressed.
Illumination will turn off about four seconds after L is released.
Illumination may be hard to see when viewed under direct sunlight.
Frequent use of illumination runs down the battery.
Shop for other wearable technology on our website.
Note
Take care that you set the
correct AM or PM time.
When changing the time,
move the minute hand four
or fi ve minutes past your
fi nal setting, and then back it
up to the setting you want.
Note
The day setting uses a
31-day month. Make
adjustments for months of
shorter lengths.
Avoid changing the day and
day of the week settings
between the hours of 9 p.m.
and 4 a.m. Otherwise, the
day and day of the week
may not change correctly at
midnight.
1
Advertisement
