Table of Contents
Advertisement
Malfunction
1 short warning tone, con
tinuously repeated, can be
heard,
the cycle indicator for the se
lected dishwashing cycle is
flashing:
the
control indicator
lights up:
Å 10
fault code
is displayed
in the multi display:
(Problems with water inlet)
2 short warning tones, con
tinuously repeated, can be
heard,
the cycle indicator for the se
lected dishwashing cycle is
flashing,
Å 20
fault code
is displayed
in the multi display. (Prob
lems with water outflow)
3 short warning tones, con
tinuously repeated, can be
heard,
Å 30
Fault code
is displayed
in the multi display.
1 long warning tone can be
heard,
The
control indica
tor is lit.
The
control indicator is
lit.
Possible cause
Water tap is blocked with
limescale or faulty.
The tap is turned off.
The filter (where present) in the
threaded hose fitting on the
tap is blocked.
Filters in the base of the dish
washer compartment are
blocked.
Water inlet hose
has not been correctly posi
tioned.
The sink outlet is blocked.
Water drain hose
has not been correctly posi
tioned.
The anti flood system has been
triggered.
The upper basket spray arm is
jammed.
The door of the dishwasher is
open.
What to do if...
Remedy
Check the water tap and have it
repaired if necessary.
Turn the tap on.
Clean the filter in the threaded
hose fitting.
Cancel the dishwashing cycle
(see chapter: Starting a dish
washing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing cy
cle again.
Check the position of the hose.
Clean out sink outlet.
Check the position of the hose.
First shut off the water tap,
then switch off the appliance
and contact the Customer Care
Department.
Open the door carefully
Hot steam may escape when
the door is opened. There is a
risk of scalding. Arrange the
dishes and cutlery in the bas
kets so that the spray arm
above can rotate freely. Close
the dishwasher door.
Close the dishwasher door.
33
Advertisement
Table of Contents
