Table of Contents
Advertisement
Chapter 2 Installation Procedure
Before you proceed with the installation, please notice following descriptions.
Note1: This Installation guides you through the proper installation of your WNL-9320.
Note1: The following installation operates under Windows XP. The procedure also applies to
Windows 2000 and Vista.
Note2: If you have installed other Wireless PC Card driver & utility before, please uninstall them
first.
Installation for Vista System
1. Physically install WNL-9320 to your computer.
2. After start up, the system will detect the device and show you "the Found New Hardware Wizard".
Please click "Cancel" to skip this step.
3. Insert the bundled CD into the CD-ROM drive to launch the auto-run program. Click the "Vista
Utility" hyperlink in the WNL-9320 field to initiate the install wizard.
Note: If the menu screen does not appear, click "Start" at the taskbar. Then, select "Run" and type
"E:\Utility\Vista\UT-WNL9320.exe", where the E is your CD-ROM drive.
4. Please follow the instructions of the Wizard to complete the whole installation.
Installation for 2000/XP System
Utility Installation
1. Insert the bundled CD into the CD-ROM drive to launch the auto run program. Once completed, a
menu screen will appear.
2. Click the "Configuration Utility" hyperlink in the WNL-9320 field to initiate the installation procedure.
Note: If the menu screen does not appear, click "Start" at the taskbar. Then, select "Run" and type
"E:\Utility\Win2KXP\UT-WNL9320.exe", where the E is your CD-ROM drive.
3. Read the License Agreement carefully. Click "Yes" to accept it and continue.
- 3 -
Advertisement
Table of Contents
