Table of Contents
Advertisement
Dimmer or
Switch Mode
Mounting
Orientation
Rigging
Mounting Diagram
Page 8 of 14
The DMX-4 has two different methods for controlling the output of the four channels. To
set this via the control panel, do the following.
1.
Unplug any units from the four output channels.
2.
Connect the DMX-4 to a suitable power outlet.
3.
Turn the product on.
4.
Press <MODE> repeatedly until A001–A512 appears on the display.
5.
Press <MENU> repeatedly until S1__, S2__, S3__, or S4__ appears on the display.
This setting can be set differently for each of the four channels. Navigate to the
desired channel.
6.
Use <> or <> to select either __oN (Switch mode) or __oF (Dimmer mode) for
the channel selected in the previous step.
7.
Repeat steps 5 and 6 to set each of the other channels, if necessary.
Before mounting the product, read and follow the safety recommendations indicated in
the Safety Notes.
The DMX-4 may be mounted in any position; however, make sure adequate ventilation
is provided around the product.
•
Before deciding on a location, always make sure there is easy access to the product
for maintenance and programming.
•
Make sure that the structure or surface onto which you are mounting the product
can support the product's weight (see the
•
When mounting the product overhead, always use a safety cable. Mount the
product securely to a rigging point, such as an elevated platform or a truss.
•
When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity. The bracket has 13-mm holes, which are appropriate
for this purpose.
•
The mounting bracket allows for surface mounting. When mounting the product on
the floor, make sure that the product and cables are away from people and vehicles.
•
The back plate may be reversed for an alternate rigging configuration.
Mounting
Clamp
Mounting
Bracket
Technical
Specifications).
DMX-4 User Manual (Rev. 2)
Safety
Cable
Advertisement
Table of Contents
