Installation
2.
Slide the transducer into the bracket and temporarily slide
the bolt through the transducer bracket.
3.
Hold the transducer assembly against the transom. Look at
the transducer from the side. If it is parallel to the ground,
then the "A" position is correct.
4.
If the transducer can not be adjusted so its face is parallel
to the ground, remove the transducer and ratchets from
the bracket. Reinsert the ratchets into the bracket, this time
with the letter "B" aligned with the dot stamped in the bracket. Reassemble the transducer
and bracket and place it against the transom.
5.
Check to see if the transducer will adjust so its face is parallel with the ground. Repeat this
process until the transducer can be adjusted so its face is parallel with the ground.
C. Assembling the Transducer bracket
After determining the correct position for the ratchets,
loosely assemble the transducer and bracket assembly.
Metal washer
Lock nut
Rubber washers
Ratchets
4
Metal washer
Bolt