Advertisement
The Front Panel (con't):
7
9: CD Input. Use these jacks to connect the output from a CD player, tape
deck, or rhythm machine to the amplifier. The CD Input jacks are post EQ
and Gain, so use the level control on the CD player (etc.) to adjust the
level of the signal at these jacks.
10: Headphones. Use this jack to connect headphones to the amplifier. The
internal speaker is disconnected when this jack is used.
11: External Speaker. Use this jack to connect the amplifier to an external
speaker. The internal speaker is disconnected when this jack is used. The
impedance of the external speaker must be 4 ohms or greater. Do not
attempt to use headphones in the External Speaker jack! Permanent
hearing damage could result.
The Rear Panel (not shown):
12: Power Switch. Use this switch to apply power to the amplifier. The amp
is on when the top of the switch is depressed, off when the bottom of the
switch is depressed. The switch illuminates when the amp is on.
13: AC Line Cord. The grounded power cord should only be plugged into a
grounded power outlet that meets all applicable electrical codes and is
compatible with the voltage, power, and frequency requirements stated
on the rear panel. Do not attempt to defeat the safety ground connection.
CA15 Acoustic Amplifier
8
9
10
11
5
Advertisement
