Attaching The Control Panel; Switching On/Off - Blaupunkt MUNCHEN MP36 Operating And Installation Manual

Control panel
u
First, pull the control panel straight off
the unit and then out towards the left.
The device switches off.
All the current settings are saved.
Any CD already inserted in the unit remains
there.

Attaching the control panel

u
Slide the control panel from left to right
into the unit's guide.
u
Carefully press on the left edge of the
control panel until it clicks into place.
Note:
When attaching the control panel, make
sure you do not press the display.
If the device was still switched on when you
removed the control panel, it will automati-
cally switch on again with the last settings
activated (i.e. radio, CD/MP3, CD changer
or AUX) when the panel is replaced.
34

Switching on/off

You can switch the device on/off in the fol-
lowing ways:
Switching on/off using the vehicle ignition
If the device is correctly connected to the
vehicle's ignition and it was not switched
off using button 1, it will switch on/off
simultaneously with the ignition.
Switching on/off using button 1
u
To switch on the device, press button
1.
u
To switch off the device, press and hold
down button 1 for longer than two
seconds.
The device switches off.
Note:
To protect the vehicle battery, the device
will switch off automatically after one
hour if the ignition is off.
Switching on by inserting a CD
If the device is switched off and there is no
CD present in the drive,
u
gently push the CD with its printed side
uppermost into the drive 5 until you
feel some resistance.
The drive draws in the CD automatically.
You must not hinder or assist the drive as it
draws in the CD.
The device switches on and starts playing
the CD.
Switching on/off