Troubleshooting Suggestions - Bloomfield Horizon 0401 Owner's Manual

TROUBLESHOOTING SUGGESTIONS

SYMPTOM
Water won't heat
No flow from dispense nozzle
Dispense nozzle drips
Unit overfills
POSSIBLE CAUSE
Dispenser unplugged or circuit
breaker tripped
Tank heater switch "OFF"
Temperature setpoint too low
Hi-Limit safety switch tripped
Damaged internal component or
wiring
Water supply OFF
Inlet solenoid strainer plugged
Dispense solenoid damaged
Water level probe grounded
Water level controller damaged
Debris in dispense solenoid
Debris in fill solenoid seat
(drips from vent tube)
Water level probe out of place or
coated with minerals
Wiring loose or damaged
Controller damaged
10
SUGGESTED REMEDY
Check power supply cord
Check / reset circuit breaker
Press switch to "ON"
Adjust thermostat for desired
temperature
Allow to cool hi-limit will self-
reset
Examine wiring & connectors,
controller, power board and
heating element
Repair/replace as needed
Turn water supply ON
Clean strainer
Replace dispense solenoid
Check / repair wiring to probe
Check / replace probe sleeve
Replace probe
Check / repair controller wiring
Replace controller
Replace dispense solenoid
Replace inlet solenoid
Clean, reinstall or replace water
level probe
Repair or replace wiring as
required. Carefully examine
ground connection for tightness
Replace controller