Table of Contents
Advertisement
Quick Links
BLOOMFIELD INDUSTRIES
10 Sunnen Drive
St. Louis, MO 63143
telephone: 314-678-6336
fax: 314-781-2714
www.wellsbloomfield.com
Model 1223-2G Dispenser
77729
p/n 2M-
Rev. G
OWNERS MANUAL
for
HOT WATER
DISPENSER
FOR EXPORT
2 GALLON MODELS:
1223-2G-230V
5 GALLON MODELS:
1226-5G-230V
Includes:
Installation
Operation
Use & Care
Servicing Instructions
M713
713
12
1002
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Bloomfield 1223-2G-230V
Summary of Contents for Bloomfield 1223-2G-230V
-
Page 1: Servicing Instructions
BLOOMFIELD INDUSTRIES 10 Sunnen Drive St. Louis, MO 63143 telephone: 314-678-6336 fax: 314-781-2714 www.wellsbloomfield.com OWNERS MANUAL HOT WATER DISPENSER FOR EXPORT 2 GALLON MODELS: 1223-2G-230V 5 GALLON MODELS: 1226-5G-230V Includes: Installation Operation Use & Care Servicing Instructions Model 1223-2G Dispenser... -
Page 2: Warranty Statement
The prices charged by Bloomfield Industries for its products original installation or eighteen (18) months from the date of are based upon the limitations in this warranty. Seller’s... -
Page 3: Table Of Contents
VOLTS WATTS AMPS POWER SUPPLY 1ø 50/60Hz 1ø CORD 1223-2G-230V 1800 Supplied IEC 1800W Minimum 1226-5G-230V 4000 16.5 Not Provided APPLICABILITY This manual applies to the following Wells Bloomfield products: 1223-2G 2-Gallon Hot Water Dispenser 1226-5G 5-Gallon Hot Water Dispenser... -
Page 4: Features & Operating Controls
FEATURES AND OPERATING CONTROLS REAR COVER REAR VIEW FRONT VIEW THERMOSTAT ACCESS READY LITE POWER LITE FLEXIBLE DRAIN LINE WATER SUPPLY CONNECTION TANK HEATER SWITCH DISPENSE IL1857 FAUCET DRAIN LINE TUBING CLAMP POWER CORD (WHEN SUPPLIED) RUBBER GRIP FEET... -
Page 5: Precautions & General Information
PRECAUTIONS AND GENERAL INFORMATION WARNING: ELECTRIC SHOCK HAZARD All servicing requiring access to non-insulated components must be performed by qualified service personnel. Do not open any access panels which require the use of tools. Failure to heed this warning can result in electrical shock. WARNING: INJURY HAZARD All installation procedures must be performed by qualified personnel with full knowledge of all... -
Page 6: Installation Instructions
1/4-turn ball valve, to avoid loss of water flow thru the must meet certain minimum valve. criteria to insure successful operation of the dispenser. Bloomfield recommends 1/4” copper tubing for installation of less than 12 feet and 3/8” for more than 12 feet from a 1/2” water supply line. - Page 7 INSTALLATION (continued) NSF requires that the unit be able to be moved for cleaning NOTE: This equipment must underneath. A flex line or loops of copper tubing will satisfy this be installed to comply with requirement. See Figure 2 below. applicable federal, state and local plumbing codes and ordinances.
-
Page 8: Operation
OPERATION FILL TUBE WATER HEATER VENT TUBE WATER LEVEL PROBE Water temperature is sensed by thermobulb WATER HEATING ELEMENT LEVEL inserted into the water tank. Temperature is CONTROL controlled by a mechanical thermostat. FAUCET WATER The setpoint temperature is adjustable by LEVEL turning the thermostat shaft. -
Page 9: Cleaning Instructions
CLEANING INSTRUCTIONS PROCEDURE: Clean Hot Water Dispenser CAUTION: BURN HAZARD PRECAUTIONS: Disconnect dispenser from electric power. Dispensed water is extremely Allow dispenser to cool. hot. Hot water will cause serious skin burns. FREQUENCY: Daily TOOLS: Mild Detergent, Clean Soft Cloth or Sponge CAUTION: Bristle Brush SHOCK HAZARD... -
Page 10: Troubleshooting Suggestions
TROUBLESHOOTING SUGGESTIONS 1223-2G & 1226-5G HOT WATER DISPENSER SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY Check power supply cord Dispenser unplugged or circuit breaker tripped Check / reset circuit breaker Tank heater switch “OFF” Press switch to “ON” Adjust thermostat for desired Temperature setpoint too low Water won’t heat temperature... -
Page 11: Servicing Instructions
SERVICING INSTRUCTIONS ACCESS PANELS CAUTION: SHOCK HAZARD REAR PANEL: Remove rear panel to access hot water tank, thermostat, Opening access panels on heating elements, tubing, water level control and plumbing this dispenser may expose connections. uninsulated electrical Rear panel is held by four screws at the back. The flanged top components. - Page 12 SERVICING INSTRUCTIONS (continued) TEMPERATURE ADJUSTMENT IMPORTANT: Check temperature at discharge of faucet. The thermostat will maintain Remove thermostat access button plug to access thermostat. temperature within ±1.5ºC. Turn thermostat shaft clockwise to increase temperature. For high altitude locations, thermostat should be adjusted to a maximum temperature equal to the local boiling temperature minus 2,75ºC.
- Page 13 SERVICING INSTRUCTIONS (continued) IMPORTANT: REPLACE HEATING ELEMENT When replacing heating Remove tank lid assembly as detailed on page 10. element, also replace seal Remove two hex nuts holding element to cover. Pull element gaskets. from mounting holes. Reassemble in reverse order. REPLACE SOLENOID Unplug power cord.
-
Page 14: Deliming Instructions
Should deliming hoses up. Rinse with clean water. become necessary, Bloomfield Reassemble the tank lid to the water tank. Make sure the recommends replacing the gasket is properly in place. Reinstall wiring to heating hoses element and thermostat. -
Page 15: Exploded View & Parts List
EXPLODED VIEWS AND PARTS LISTS BONNET & PLUNGER ASSY. SEAT CUP FAUCET INLET FITTING 2U-71460 & SHANK KIT WS-85218 COMPLETE 2U-74686 SCREEN WS-85219 WASHER SHANK FITTING (TANK FITTING) FAUCET BODY IL1859 SERVICE KITS FAUCET REPAIR KITS 2U-74686 Faucet & Shank Complete 2U-71460 Seat Cup (only) SOLENOID REPAIR KITS... - Page 16 EXPLODED VIEW: 1223-2G-230V, 1226-5G-230V 2 REQD 2 REQD 1223-2G ONLY Model: 1223-2G-230V, 1226-5G-230V IL1856 Rev. A 8/05/09 NOTE: Model 1223-2G shown. Model 1226-5G is similar.
- Page 17 PARTS LIST: 1223-2G-230V, 1226-5G-230V ITEM DESCRIPTION 1223-230V 1226-230V WRAP, BODY TANK ASSY PANEL, TOP BACK PLUG, BUTTON 7/8” 2P-70714 SUPPORT, TANK LIGHT, PILOT GREEN 2J-72671 LABEL, HW DISPENSER LIGHT, PILOT AMBER 2J-30516 CONTROL, LOW WATER, 240V 2E-306865 SPACER, NYLON PANEL, REAR LOWER...
-
Page 18: Wiring Diagrams
WIRING DIAGRAM 2-GALLON MODEL 1223-2G... - Page 19 WIRING DIAGRAM (continued) 5-GALLON MODEL 1226-5G HOT WATER READY LIGHT (AMBER) POWER BLACK BLACK LIGHT (GREEN) THERMOSTAT BLACK BLACK HEATING ELEMENT 4000 WATTS WHITE COMM WATER LEVEL CONTROL N.O. BOARD TANK WATER HEATER N.C. LEVEL SWITCH PROBE HI-LIMIT BLACK RED12ga. INPUT COMM GREEN...
- Page 20 10 Sunnen Drive, St. Louis, MO 63143 telephone: 314-678-6336 fax: 314-781-2714 www.wellsbloomfield.com...
Need help?
Do you have a question about the 1223-2G-230V and is the answer not in the manual?
Questions and answers