Displaying The Camera Angle; Switching The Coaxial Digital Output (Spdif) On/Off; Configuring The Audio Output; Dual Mono" Setting - Blaupunkt DVD-PLAYER MEU2 Operating And Installation Manual

Displaying the camera angle

You can set the system to display a "
camera symbol whenever there is more
than one camera angle available on the
DVD. To do so, select the "ON" setting.
You can adjust the camera angle set-
ting in the "ANGLE MARK" menu item
in the "GENERAL SETUP" menu.
Switching the coaxial digital
output (SPDIF) on/off
If you connect the ME2 to an amplifier
using the digital (SPDIF) input, you must
activate the SPDIF output on the ME2.
To do so, select the "ON" setting.
You can adjust the digital output setting
in the "SPDIF OUTPUT" menu item in
the "AUDIO SETUP" menu.

Configuring the audio output

If the device is installed in the vehicle,
you should connect it to the vehicle's
system (amplifier, monitor) via the line
output. Alternatively, you can also con-
nect headphones to the infrared receiv-
er input (left-hand side of the device,
REMOTE SENSOR).
If you want to use headphones, select
the "RF REMOD" setting under "OP
MODE" in "AUDIO SETUP".
Note:
Generally, the line output should be
used ("LINE OUT").
SETUP – BASIC SETTINGS

"Dual mono" setting

" For DVDs with 1+1 audio mode (two
mono channels), you can set how you
want the two channels to be outputted.
The following settings are available:
Stereo:
Stereo playback of a 1+1 pro-
gramme. Channel 1 is sent to the
left output and channel 2 to the
right output.
CH1-Mono:
Channel 1 of the DVD is played on
both outputs (left and right).
CH2-Mono:
Channel 2 of the DVD is played on
both outputs (left and right).
Mix Mono:
Channel 1 and 2 of the DVD are
played on both outputs (left and
right).
Open the setup menu.
Use the
the "AUDIO SETUP" menu item.
Confirm your choice by pressing
the ENTER/PLAY button B.
Use the
the "DUAL MONO" menu item.
Press the
Use the
the setting that you want.
Confirm your choice by pressing
the ENTER/PLAY button B.
Close the setup menu by pressing
the SETUP button D.
The settings are saved and the setup
menu closes.
< buttons to select
< buttons to select
button <.
buttons < to select
51