Pro-Form 6.75q User Manual page 8

CONSOLE DIAGRAM
Incline
Note: If there is a thin sheet of clear
plastic on the face of the console,
remove it before operating the console.
CAUTION:
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) whilst using the treadmill. When the
key is removed from the console, the walk-
ing belt will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
BATTERY INSTALLATION
UNPLUG THE POWER CORD. The console re-
quires 1.5 V batteries (included). Alkaline batteries
are recommended. Open the battery cover as shown in
the drawing at the upper right. Insert the batteries into
the battery compartment, making sure that the negative
(–) ends of the batteries are touching the springs in the
battery compartment.
Before operating the
Speed Control
Batteries
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
inset drawing. Make sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See page 7.)
Stand on the foot rails of the treadmill. Find the clip at-
tached to the key (see the drawing at the top of this
page), and slide the clip onto the waistband of your
clothes. Next, insert the key into the console. Test the
clip by carefully taking a few steps backward until
the key is pulled from the console. If the key is not
pulled from the console, adjust the position of the
clip as needed.
8
Pulse Sensor
Key/Clip
Battery
Tab
Cover