AEG Electrolux LAVATHERM 58800 User Information page 34

1. Open loading door.
2. Unscrew hinge A from the front of
the machine and take off the load-
ing door.
3. Remove cover plates B and C. To do
this, insert a thin screwdriver into
the slots as shown in the illustra-
tion, press downwards slightly and
pry out the cover plates.
4. Use an appropriate tool and exert
pressure to unfasten locking block D
from the snap-on fixture, take out
and reinsert on the other side hav-
ing rotated the block through 180°.
5. Unscrew hinge A from the loading
door, rotate through 180°, reinsert
on the opposite side and screw
down.
6. Reinsert cover plates B and C on the opposite site having first rotated
them through 180°.
7. Unscrew cover plates E from the
front of the machine, rotate
through 180°, screw on the
opposite side.
8. Unscrew door lock F, push down
slightly and remove from the front
of the machine.
9. Disconnect cable connector from
door lock F.
10. Press snap-in button G in and
down, press cover down slightly
and remove from front of the ma-
chine.
11. Disconnect cable connector from
cover G.
12. Change door lock F over to the op-
posite side, insert the cable con-
nector and screw down the door
interlock.
13. On the other side, insert the cable connector in cover G, insert cover
and allow snap-in button to lock into place.
34