Table of Contents
Advertisement
• For extractor versions (13A), connect the other end of the exhaust pipe to the flue.
For filter versions (13F), fit deflector F to the truss and secure it to the bracket supplied using 4 screws, then
connect the exhaust pipe to the connection ring located on the deflector.
• Fit the nuts with fixing hooks (14) supplied inside the top and bottom sections of the flues at the rectangular
slots. A total of 10 nuts must be fitted.
• Join the two top sections of the flue to cover the truss (15) so that one of the slots on the sections is situated
on the same side of the control panel and the other on the opposite side. Screw the two sections together with
4 screws (2 each side- see the plan diagram for joining the two sections).
• Fix the top flue assembly to the truss, near the ceiling, with two screws (16 - one each side).
• Carry out electrical connection of control panel and bulbs (17).
Fig. 11
52
Advertisement
Table of Contents
