Care Of Your Quilt Designer Ii; Changing Light Bulbs - Husqvarna Quilt Designer II User Manual

Care of your Quilt Designer II

Quilt Designer II is equipped with two lights, one is
placed to the left of the needle (A) and the other up
to the right (B). Use light bulb de sig ned as in di cat ed
on the front of the machine. They are available at
your authorized Husqvarna Viking dealer.
Changing the Light Bulb (A)
Turn off the main switch.
1. Place the rubber sheath found in the ac ces so ry
box with its deep hole, marked OUT,
around the bulb.
2. Do not turn the bulb, just pull it down to re move
the bulb.
3. When inserting, place the rubber sheath with its
shallow hole, marked IN, aro und the new bulb,
insert the bulb by pushing it up. Make sure the
bulb is correctly inserted.
Changing the Light Bulb (B)
1. Remove the plastic guard by pulling slightly
downward.
2. Place the rubber sheath found in the ac ces so ry
box with its deep hole, marked OUT, around the
bulb.
3. Do not turn the bulb, just pull it out to remove the
bulb.
4. When inserting, place the rubber sheath with its
shallow hole, marked IN, aro und the new bulb,
insert the bulb by pushing it up.
5. Replace the plastic cover by inserting the rear
edge and press it into the holder.
68
Care of your Quilt Designer II
A
1.
B
3.
OUT
N I
OUT
2.
N I
I N
I N
3.
OUT
1.
5.
2.
4.