Table of Contents
Advertisement
2. Then start by zipping the zipper about 3 inches
(8 cm), to hold the window in place. When zipping,
place the rear bottom corner of the window inside
the rear part of the vehicle body to help support
the window while you engage the zipper end.
3. Install the plastic strip into the window channel
before completely zipping the window. There is a
locating pin in the front upper corner to assist in
aligning the window.
4. Pull rearward on the rear edge of the window to
make sure the window is secure and finish zipping
the window.
5. After completing installation, make sure that the
front and bottom ends are securely hooked and the
rear top end of the window is under the canvas top.
6. Refasten the plastic clip at the top front corner of the
side window. Restore the tension to the canvas top
support arms.
2-59
Advertisement
Table of Contents
