BX3
The BX3 supports (3) 168-pin DIMMs (Dual In-line Memory Module). The
DIMMs can be either EDO (Extended Data Out) or SDRAM (Synchronized
DRAM). The DIMMs may be installed using just one chip.
•
We recommend using SDRAM DIMM can not mixing
with EDO DIMM modules.
•
The EDO DIMM only support pentium
support Pentium III Processor at 100MHz.
•
We recommend when installed the 100MHz Pentium III Processor
using DIMM SDRAM must be 125MHz (-8ns) bus speed. If used
100MHz (-10ns) SDRAM may be critical timing for the
motherboard.
•
About the "PC/100 SDRAM spec." information you may visit Intel's
home page at:
http//developer.intel.com/design/pcisets/memory/index.htm
•
DIMM SDRAM may be 83MHz (-12ns), 100MHz (-10ns) or
125MHz (-8ns) bus speed.
Figure 2 and Table 1 show several possible memory configurations using
F igu re 2
Installation
®
II Processor at 66MHz, not
B ank 0
-Sy n chronou s
B ank 1
-SD R A M or E D O
D IM M
B ank 2
Page 6