Related Manuals for EPOX BX3
Summary of Contents for EPOX BX3
- Page 1 motherboard TRADEMARK All products and company names are trademarks or registered trademarks of their respective holders. These specifications are subject to change without notice. Manual Revision 3.2 July 23, 1999...
- Page 2 Supports (2) 16 bit ISA slots, (5) 32 bit PCI slots, (1) AGP slot and provides (2) independent high performance PCI IDE interfaces capable of supporting PIO Mode 3/4 and Ultra DMA 33 devices. The BX3 supports (5) PCI Bus Master slots and a jumperless PCI INT# control scheme which reduces configuration confusion when plugging in PCI card(s).
-
Page 3: Lan Connector
Features • BX3 utilizes a Lithium battery which provides environmental protection and longer battery life. • Supports the Universal Serial Bus (USB) connector. The onboard PIIX4E chip provides the means for connecting PC peripherals such as; keyboards, joysticks, telephones, and modems. - Page 4 Installation BX3 Detailed Layout Figure 1 Page 3...
-
Page 5: Installation
Installation The following must be completed before powering on your new system: Configure Jumpers to match your hardware Install memory chips Device Connectors motherboard We design this with the an ESDJ to make your install fast and easy. The following will describe all of the ESDJ that you are required to set before moving on to step 2. - Page 6 * : RSD (Reserved) ** : ESDJ (Easy-Setting-Dual-Jumper) Note: Based on the implementation of Intel 440BX PCIset, BX3 is able to provide two host bus frequencies -- either 66 or 100MHz for Slot1 processor and memory operating. The default is set at 100MHz once Pentium II processor to ®...
- Page 7 Installation The BX3 supports (3) 168-pin DIMMs (Dual In-line Memory Module). The DIMMs can be either EDO (Extended Data Out) or SDRAM (Synchronized DRAM). The DIMMs may be installed using just one chip. • We recommend using SDRAM DIMM can not mixing with EDO DIMM modules.
- Page 8 Installation Table 1 * SDRAM only supports 8, 16, 32, 64, 128MB DIMM modules. 256MB only supports Registered Synchronouts DRAM Memory Modules. ® * EDO only supports Pentium II Processor at 66MHz, not supports Pentium III Processor at 100MHz. Page 7...
- Page 9 Installation Reset - Closed to restart system. Speaker - Connect to the system's speaker for beeping 1. Speaker 3. GND 2. N/C 4. GND KeyLock - Keyboard lock switch & Power LED connector 1. Power LED(+) 4. Keylock 2. N/C 5.