Table of Contents
Advertisement
Problem
Drying cycle ends
shortly after pro-
gramme starts. END
(ENDE) display illumi-
nated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete").
Changing bulb for inside light
Only use a special bulb which is designed specially for dryers. The spe-
cial bulb is available from the after-sales service,
ET-Nr. 112 552 000-5.
3
Important: When the appliance is switched on, the interior lighting
switches itself off after 5 minutes when the door is open.
1
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
1
Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly
behind the loading aperture, at the top; refer to "Description of ma-
chine" section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1
Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be op-
erated.
Possible cause
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Lint filter clogged.
Fluff filter blocked with
fluff.
Load volume too big.
Laundry insufficiently pre-
drained.
Particularly high room
temperature. Temporary
switching off of the
compressor to avoid
overload.
Remedy
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY [STARKTROCKEN] in-
stead of STORAGE DRY
[SCHRANKTROCKEN]).
Clean lint filter.
Clean the fluff filter.
Reduce load volume.
Laundry must be adequately
pre-drained.
Automatic process, there is no
fault with the appliance. If
possible, lower the room
temperature.
23
Hide quick links:
Advertisement
Table of Contents
