Changing The Bulb For Interior Lighting - AEG LAVATHERM 59800 User Information

Problem
PROGRAMME TIME
display changes errati-
cally or stays un-
changed for a long
time.
Programme inactive,
EMPTY WATER display
illuminated.
Drying cycle ends
shortly after pro-
gramme starts. END
display illuminated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete").

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The spe-
cial bulb can be obtained from the Customer Care Department, ET no.
112 552 000-5.
3
Important: When the appliance is switched on, the interior lighting
switches itself off after 5 minutes when the door is open.
1
Warning: Do not use standard bulbs! These develop too much heat and
may damage the appliance.
1
Warning: Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the
loading aperture, at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
1
Warning: For safety reasons, the cover must be screwed down tightly.
If this is not done, the dryer must not be operated.
22
Possible cause
Programme time is correct-
ed automatically depending
on type and volume of
laundry and level of damp-
ness.
Condensate tank is full.
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Remedy
Automatic process; this is not
a machine fault.
Empty condensate tank, then
start programme with START/
PAUSE button.
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY instead of STORAGE
DRY).
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately
spun.