Changing Bulb For Inside Light - AEG LAVATHERM 55600 User Information

Problem
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete").

Changing bulb for inside light

Only use a special bulb which is designed specially for dryers. The spe-
cial bulb is available from the after-sales service,
ET-Nr. 112 552 000-5.
1
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
1
Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly
behind the loading aperture, at the top; refer to "Description of ma-
chine" section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1
Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be op-
erated.
Possible cause
Lint filter clogged.
Heat exchanger clogged
with lint.
SPECIAL CARE (LAGE TEMP.)
button pressed and load
volume too big.
Load volume too big.
Laundry insufficiently pre-
drained.
Remedy
Clean lint filter.
Clean heat exchanger.
SPECIAL CARE (LAGE TEMP.) is
only suitable for use with
loads of up to 2,5kg!
Reduce load volume.
Laundry must be adequately
pre-drained.
21