Chicco NextFit User Manual page 29

INSTALL USING LAP BELT ONLY
4 While pushing down on the Child Restraint (a) pull the loose end of
the vehicle lap belt (b) to tighten belt.
CHECK YOUR WORK

Hold Child Restraint at each side near REAR-FACING vehicle belt paths. Pull side
to side and forward. Vehicle belt should remain tight and Child Restraint should
not move more than 1" (25 mm) from vehicle seat back or side-to-side.

Make sure Child Restraint is level for REAR-FACING use. Make sure infant's head
does not fall forward. If necessary, loosen the vehicle belt, re-adjust recline and
repeat installation steps to make sure Child Restraint is installed properly.

Check installation before every use!
54
INSTALL USING LAP BELT ONLY
4a
4b
55