Testing The Motion Detector; Testing The Smoke Detector (Optional Feature) - BRINKS DCU-500 Manual

TESTING THE MOTION DETECTOR

You can test the motion detector without sending alarm signals to
the Brink's Monitoring Center.
1. Make sure there is no movement in the area protected by
motion detector.
2. Press and hold the "6" key for 3 seconds.
3. All zone lights will flash rapidly.
4. Walk through the protected area. If your motion is detected, the
siren will give a short blast. (If your motion was not detected, call
Brink's Customer Service. A service call may need to be
scheduled to adjust the motion detector.)
5. When you are finished testing the motion detector, exit the sensor
test mode by pressing CANCEL.
NOTE: If the CANCEL key is not pressed, the SENSOR TEST is
automatically canceled in five minutes.
TESTING THE SMOKE DETECTOR
The smoke detector can be tested without sending alarm signals to
the Brink's Monitoring Center. Call Brink's Customer Service at
1-800-445-0872 for assistance in testing the smoke detector.
CAUTION: Do not attempt to test the smoke detector with canned
smoke, heat, or flame. These methods may damage the smoke
detector.
(Optional Feature)
14