Table of Contents
Advertisement
23. Attach the two wires from the cross lighter
as shown to small terminals on ignitor
module as shown.
Attach two wires from console
assembly to two large terminals
as shown.
Correct
NOTE: Use one of the supplied plastic
ties to bundle the two large terminal wires
together, and one to bundle the four small
terminal wires together.
24. After wiring ignitor module ensure that all burner knobs
are in the off position before installing the battery.
Install the battery
Incorrect
.
25. Snap ignitor module tabs into
into holes on back left side of front
panel as shwon.
NOTE: Do not remove ignitor module
once installed. The plastic mounting tabs
on the ignitor "hook" into the mounting
holes and are not designed to be repeatedly
removed and re-installed. Replace battery in
module with module in place.
21
Advertisement
Table of Contents
