Table of Contents
Advertisement
INSTALLATION – IMPORTANT NOTICE
The operational setting up of household appliances in their environment is a
delicate operation that, if not done correctly, can have serious consequences
for consumer safety.
Therefore, this work must be entrusted to a professional who can carry it out
in compliance with the technical standards in force.
However, if despite this recommendation, the consumer carries out the
installation themself, Candy will not accept any responsibility in case of technical
failure of the product whether or not it causes damage to goods and/or persons.
INSTALLATION – ELECTRICAL CONNECTION
«The installation receiving the appliance referred to must comply with the standard in force in
the installation country».
The CANDY company does not accept any responsibility if this provision is not complied with.
Caution:
• Before connecting, check the power supply voltage shown on the meter, the circuit
breaker setting, the fuse rating and the earth continuity of the installation.
• Connection to the network must be by earthed socket outlet, or by means of a multi-
pole circuit-breaker having a distance between contacts of at least 3 mm.
If the appliance has a socket outlet, it must be installed so that the socket outlet
is accessible.
• The green/yellow protection wire must be linked to the earth terminals, of the appliance
on one side, and the installation on the other side.
• The manufacturer will not be liable for any incident, or the possible
consequences that may arise from the use of the oven not earthed, or connected
to an earth with defective continuity.
• All work in relation to the power supply cable must be carried out by the after sales
service or someone with similar qualifications.
The hob comes without power supply cable. It is equipped with a terminal board for
selecting the type of electrical connection appropriate to the installation.
The terminal board has two connection options:
. Single phase
. Three phase
The installation must be protected by an appropriate fuse, see table page 25, and
have wires with large enough cross-section to supply the appliance normally.
The power supply cable must be selected according to the information of table page
25.
2 2 -
230 V~
400 V2N~
Hide quick links:
Advertisement
Table of Contents
