Related Manuals for GMC 230W
Summary of Contents for GMC 230W
- Page 1 INSTRUCTION MANUAL 230W 3 in 1 Combination Sander • Melbourne • Perth • Auckland • Hong Kong • Shanghai • Taipei • New York • Verona • London • Paris MOS230 040330 MOS230 ED9...
-
Page 2: Table Of Contents
Description of symbols Specifications Safety instructions Additional safety rules for sanders Accessories Unpacking Know your product Switching on and off Using the sander Changing the base Fitting a sanding sheet Selecting the right grade of sandpaper Dust extraction Maintenance General inspection Repairs... -
Page 3: Introduction
Overall detail sanding sheet size: 1/3 Sheet sanding sheet size: Net weight: Length of cordset: This sander is double insulated. There are two independent barriers of insulation to protect you from the possibility of electric shock. 230-240V ~ 50Hz 230W... -
Page 4: Safety Instructions
Safety Instructions WARNING. Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. -
Page 5: Additional Safety Rules For Sanders
After long working periods external metal parts and accessories could be hot. • Do not force the sander; let the tool do the work at a reasonable speed. Overloading will occur if too much pressure is applied and the motor slows resulting in inefficient sanding and possible damage to the sander motor. -
Page 6: Accessories
Rags, cloths, cord, string and the like should never be left around the work area. Wear goggles Wear ear defenders Wear a breathing mask Accessories The GMC 3 in 1 Combination Sander is supplied with the following accessories as standard: • Detail sanding base • Random orbital sanding base •... -
Page 7: Know Your Product
Know your product 1. On/off switch 2. Handle 3. Dust extraction canister 4. Fixing screws (x 4) 5. Allen key 6. Detail base 7. Random orbital base 8. 1/3 Sheet base... -
Page 8: Switching On And Off
Let the motor reach full speed then carefully begin sanding. Remove the sander form the workpiece before switching off. WARNING. Do not use the sander in wet or damp conditions. Changing the base WARNING. Always ensure that the tool is switched off and the plug is removed from the power point before making any adjustments or maintenance procedures. -
Page 9: Selecting The Right Grade Of Sandpaper
1. Attach the dust extraction canister (3) to the sander by pushing and twisting the bayonet fitting in a similar action to inserting a light globe into a lamp. -
Page 10: General Inspection
General Inspection Regularly check that all the fixing screws are tight. They may vibrate loose over time. Repairs Only an authorised service centre should replace the cordset or carry out other repairs. If the cordset is damaged or worn, have it replaced by an authorised service centre. - Page 12 Carefully read the entire Instruction Manual Before returning this product for a Warranty Claim or any other reason Please Call 1300 880 001 (Australia) or 0800 445 721 (New Zealand) When you make your call, please have the following information at hand: •...