Setting The Message Alert - BT RESPONSE 55 User Manual

Using your
Response 55
Setting the answer delay
Answer delay sets the number of
times your Response 55 will ring
before answering a call.
Time saver
Your Response 55 is pre-set to TIME
SAVER. This means that during
remote access if any messages have been
recorded your Response 55 will answer
after only 2 rings. If there are no
messages, it will answer after 6 rings,
thereby allowing you to hang up and
avoid the cost of a call.
To change the answer delay
SKIP
Press and hold the
•
Your Response 55 announces the
current answer delay setting,
while display shows the setting.
Keep holding the
•
Response 55 announces the
answer-delay options: "
SAVER, 2, 3, 4, 5, 6, 7, 8, 9
When you hear your desired
•
setting, release the
After 2 seconds your Response 55
announces the new answer-delay
setting and returns to answer-on
mode.
13
button.
button. Your
TIME
".
button.

Setting the message alert

Your Response 55 will display the
number of messages left. It will also
beep to let you know that new
messages have been left.
To switch the message alert
on/off
SKIP
Press and hold the
•
Your Response 55 will announce
"Message alert off". Display
shows . Message alert is now
off.
Press and hold the
•
again. Your Response 55 will
announce: "Message alert on."
Display shows . Message alert
is now on. A beep will be heard
every 6 seconds when new
messages have been left.
When message alert is selected, the
beep is silenced by playback of messages
and memos.
When you have made your selection,
your Response 55 returns to
answer-on mode.
button.
button