Building Over A Kitchen Unit With Door; Fitting The Hob To The Worktop - AEG 69802 G Operating Instructions Manual

Hide thumbs Also See for 69802 G:

Table of Contents

Instructions for the Installer

Building over a kitchen unit with door

Proper arrangements must be taken in

designing the furniture unit, in order to

avoid any contact with the bottom of the

hob which can be heated when it is

operated. The recommended solution is

shown in diagram 3.

The panel fitted under the hob ("a")

should be easily removable to allow easy

access if technical assistance is needed.

The space behind the kitchen unit ("b")

can be used for connections.

Before fitting the hob into the cut out,

an adhesive seal must be fitted to the

underside outside edge of the hob. It is

essential that no gaps are left in this seal in

order to prevent spillage near the hob

seeping into the cabinet below.

# # # # #

Remove the pan supports, the

burners caps and crowns and turn the hob

upside down, taking care the ignition

candles are not damaged in this operation.

Place the relevant sealing all around

the glass top edge, taking care that the

sealings meet without overlapping (Fig. 8).

Place the hob in the cut out, taking

care of its centring.

Fix the hob with the relevant screws

(Fig. 9).

Dimensions are given in mm.

FO 1013

a) Sealing gasket

FO 2108

Table of Contents