Electrolux EHH6332FOK User Manual page 14

14 www.electrolux.com
and a number come
on.
comes on.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.
Make sure, you operated the appliance
correctly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer serv-
ice and conditions of guarantee are in the
guarantee booklet.
Problem Possible cause and
The cookware is incor-
rect.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
There is an error in the
appliance.
There is an error in the
appliance because a
cookware boils dry. The
overheating protection for
the cooking zones and
the Automatic Switch Off
operate.
Remedy
Use the correct cookware.
Move cookware to a small-
er cooking zone.
Disconnect the appliance
from the electrical supply
for some time. Disconnect
the fuse from the electrical
system of the house. Con-
nect it again. If comes
on again, speak to the
service centre.
Deactivate the appliance.
Remove the hot cookware.
After, approximately 30
seconds, activate the
cooking zone again. If the
cookware was the prob-
lem, the error message
goes out of the display, but
the residual heat indicator
can stay. Let the cookware
become sufficiently cool
and refer to "Cookware for
the induction cooking
zone" to see if your cook-
ware is compatible with the
appliance.