Things You Need To Know; Warnings; Things To Note - Electrolux EDB 872 Instruction Booklet

INSTALLATION INSTRUCTIONS

THINGS YOU NEED TO KNOW

WARNINGS:

In the interest of safety this appliance must
be installed and / or serviced by a competent
person (Corgi registered). Safety may be
impaired if installation is not carried out in
accordance with these instructions.
This cooker must be earthed.
Do not remove the screws from the earth tab
extending from the oven mains terminal block
(Fig. 1).
Before connecting the cooker make sure that
the gas type and the voltage of your
electricity supply is the same as that indicated
on the data plate. The data plate can be seen
on the rear panel of the appliance.
Do not alter the electrical circuitry of this
cooker.
NOTE: HOUSE CIRCUIT
Earth leakage / continuity tests must be carried
out before the cooker is connected to the mains
supply and re-checked after fitting.
NOTE: It is good practice to:
Fit an Earth Leakage Circuit Breaker to your
house wiring.
Wire your appliance to the latest IEE
regulations.

THINGS TO NOTE

LOCATION OF APPLIANCE
The appliance may be located in a kitchen, a
kitchen/diner or bedsitting room, but not located
in a bathroom or shower room.
L.P.G. cookers MUST NOT be installed below
ground level i.e. in a basement or aboard any
boat, yacht or other vessel.
It is essential that there is a minimum
clearance of 2mm between the top surface
of the appliance and the inside top of the
cabinet.
This cooker is designed to be fitted between
cabinets with the recommended dimensions
as shown in Figs. 2 and 3.
40
Fig.1
Fig.2
Fig.3