Operating Sequence - Electrolux EDC 5330 Instruction Booklet

Operating sequence

Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door (see picture).
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Select the drying programme or time. The lights
, and come on. The light of the
START/PAUSE button
display shows the duration of the programme.
6. If required, press the low temperature button
and/or the "Buzzer OFF"
drying" button .
7. Select the " " if required. The selected delay
appears on the display for 3 seconds, then the
duration of the selected programme is displayed.
8. Press the START/PAUSE
corresponding light stops flashing and drying
starts. Only the light
selected the delayed start, the machine begins
its countdown.
If the programme selector dial is turned to
another position, when the machine is running,
the buzzer will sound, the programme phase
indicator lights will flash and Err appears on the
display.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase light
flashes and the
button or the "Quick
button the
remains lit. If you have
is on).
You may remove the laundry after this phase.
The lights , and
The display shows a static zero.
9. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing
phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing phase.
Lights , and
sounds every 10 seconds for 2 minutes.
The light of the "START/PAUSE"
off and a flashing zero appears on the display.
10. Turn the programme selector dial to "0"; all the
lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the selector dial to "0" all the lights
corresponding to the phases making up the
performed programme come on and the
display shows the duration of the programme.
After each use
• Clean the filters (see page 13).
• Empty the water reservoir (see page 14).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position
until the end of this cooling phase before removing
the laundry. This will avoid a build-up of heat inside
the appliance.To do this first turn the dial to "0" and
then to and depress "START/PAUSE"
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
"0". Select the new programme and press the
"START/PAUSE" button.
11
illuminate.
remain lit and the buzzer
button goes
and wait
button .