Something Not Working - Electrolux EDC 504M Instruction Booklet

Something not working?

Before contacting your local Service Centre, please make the following checks:
Important!
If during the drying phase the END pilot light starts blinking and the buzzer sounds, please switch your tumble
dryer off and contact your local Service Centre.
Problem
• The dryer does not work:
• The dryer does not dry properly:
If, after the above checks, there is still a fault, call
your local Service Centre.
Please make sure you give the model and serial
number of the appliance.
Possible cause
• The door(s) is(are) open.
• The plug is not fitted into the wall socket.
• There is no electricity supply from the wall socket.
• The selector dial is not set correctly.
• The water reservoir is full or not correctly inserted
(light is on ) . The programme starts in any case
but it stops after approx. 4 minutes.
• The start button
• The DELAYED START option has been selected.
• The filters are clogged.
• The condenser is clogged.
• The water reservoir is full.
• The selected cycle is not suitable for the laundry.
• Insufficient drying time.
• The laundry has not been spun properly.
• The low temperature function
selected.
• Excessive laundry load.
• The dryer is not correctly installed.
This information can be found on the rating plate
(see picture on page 49).
57
has not been depressed.
has been