Operating Sequence - Electrolux EDC 5310 Instruction Booklet

125992320 gb.qxd 16/10/2003

Operating sequence

Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door.
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Select the drying programme or time. The lights
, and
6. If required, press the low temperature button
and/or the buzzer OFF button
QUICK drying button
7. Select the DELAYED START
8. Press the Start button
light stops flashing and drying starts. Only the
light remains lit. If you have selected the
delayed start, the machine begins its countdown.
If the programme selector dial is turned to
another position, when the machine is running,
the buzzer will sound and the programme phase
indicator lights will flash.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (light
You may remove the laundry after this phase.
The lights ,
9. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing
phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing phase.
Lights , and
sounds for 2 minutes.
10:42 Pagina 9
come on.
or the
.
if required.
: the corresponding
is on).
and illuminate.
remain lit and the buzzer
10. Turn the programme selector dial to "0"; all the
lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the selector dial to "0" all the lights
corresponding to the phases making up the
performed programme come on.
After each use
• Clean the filters (see page 11).
• Empty the water reservoir (see page 12).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position
until the end of this cooling phase before removing
the laundry. This will avoid a build-up of heat inside
the appliance.To do this first turn the dial to "0" and
then to and depress Start button
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
"0". Select the new programme and press the Start
button .
9
and wait
.