Buffalo WAPS-APG600H User Manual page 51

Administrator Name
Administrator Password
Username
Password
AirStation Name
Management Protocol
SNMP Version
SNMP Get Community
SNMP Set Community
SNMP Trap
SNMP Trap Community
SNMP Trap Manager
Enter the administrator username for logging into Settings. You may
enter 4-16 single-byte alphanumeric characters and hyphens (-). Don't
use a hyphen as the first or last character.
Set the password of the administrator. You may enter 6-32 single-byte
alphanumeric characters and symbols.
Enter the username for logging in to Settings. The user specified here
cannot change the settings. You may enter 4-6 single-byte alphanumeric
characters and hyphens (-). Don't use a hyphen as the first or last
character.
Set the password of the user. You may enter 6-32 single-byte
alphanumeric characters and symbols.
Enter the AirStation name. This name is used in syslog and other
locations. You may enter 1-32 single-byte alphanumeric characters and
hyphens (-). Don't use a hyphen as the first or last character.
Select the interfaces of Settings.
HTTP
Enables access from the browser using HTTP.
HTTPS
Enables access from the browser using HTTPs.
SNMP
This is a setting interface that enables access from manager software
that supports SNMP protocol (Version 1/2c).
Select the SNMP protocol version.
v1/v2c
This is compatible with managers that support SNMPv1 and SNMPv2c. To
access MIB, use a (Get/Set/Trap) community.
v3
This is compatible with managers that support SNMPv3 USM
(authentication method is MD5, encryption method is DES). To read
MIB (get), use "administrator name and password" or "username and
password". To write MIB (Set), use "administrator name and password".
Note: For v3, use a password with at least 7 characters.
Enter the community name (6-32 characters) that is specified when
"GETRequest" is sent by the SNMP manager to the AirStation.
Enter the community name (6-32 characters) that is specified when "SET
Request" is sent by the SNMP manager to the AirStation.
Select whether enable or disable trap transmission with the AirStation's
SNMP agent. Disabled by default.
Enter the community name (6-32 characters) that is used to send "Trap
Notification" to the SNMP manager. The default value is "public".
Specify the destination host to which "Trap Notification" is sent. SNMP
manager of the destination host must be working. The default value is
blank.
51