Buffalo WAPS-APG600H User Manual page 31

Max Age
Transmit Hold Count
Auto Edge
Bridge Port Settings
If cannot receive BPDU from the root bridge by the time set as "Max Age",
the AirStation starts reconfiguration of the bridge. 6-40 seconds can be
set. The default value is 20 seconds.
Note: This setting is enabled when the AirStation is works as the root
bridge. If it is not the root bridge, this setting is ignored.
Specify the maximum number of BPDU sent in 1 second. 1-10 can be
entered. The default value is 6.
Select whether enable or disable auto edge. If enabled, the port which
does not receive BPDU for 3 seconds works as the edge port. Disabled by
default.
Configure the information of each ports. This information enables the
spanning tree protocol to calculate the best route to reconfigure the
bridge.
Port Priority
Set the priority of each ports. Smaller value is prioritized when the path
costs of each ports are same. You may enter up to 240. The default value
is 128.
Path Cost
Set the cost for the frame forwarding of each ports. Generally,
configure the cost depending on wired or wireless device standard,
communication rate. In spanning tree protocol, the route whose total
cost is lowest is used actually. 1-200000000 can be entered. The default
value is 20000 for wired port, 200000 for wireless port.
Edge Port
Select whether enable or disable edge port. Edge port is effective when
you connect your device which does not have any bridge to the port.
After the connection, you can communicate immediately. Disabled by
default.
Point to Point
If enabled, the port connect one for one to the other bridge. The default
is "Auto-select".
31